机械安装翻译-中译英
Unitrans世联
| 机械翻译当中，有很多安装说明是需要翻译的，以下就是世联北京翻译公司资深译员对加热器机械安装说明翻译。
Install 1、加热器应水平安装，并且要安装牢固。并注意适当的保护。电器部件应朝向加热器舱体外，以便利于加热器的维修，保养。同时，要保证加热器的助燃空气进气充分，以便加热器能正常工作。 The heater should be securely installed horizontally. Protection should be available wherever it is necessary. Electric components should face outward of the heater housing to facilitate repair and maintenance. In addition, sufficient combustion air should be supplied to the heater; otherwise, the heater may not operate normally. 2、加热器的滴油管、排气管应伸出加热器安装舱外，并保证排气通畅。一般情况不要再外接排气管，以防排气阻力大影响加热器的燃烧。 The oil drop pipe and the exhaust pipe of the heater should extrude outside of the installation housing of the heater. Do not block the exhaust path. Generally no extension should be used on the exhaust pipe; otherwise, the heater may suffer from insufficient combustion due to the increased exhausting resistance. 3、加热器的燃油可从汽车主油箱中取，也可从配置的油箱中取。如从主油箱取油，须单走一路，不可与车内其它设备输油管混接。输油管采用φ6×1的铜管或亚大管，接头采用M12×1.25标准锥型接头。油管接头要牢固，不得漏气。油箱燃油液面不得低于加热器中心400mm,加热器滤油电磁阀进油接头与油箱距离(即油管长度)应在8m以内.第一次使用加热器时,因油路较长,所以加热器启动时间会略长一些,请您耐心等待3-4分钟。如果加热器还未启动,请关闭加热器,再重新启动一次。 The heater may source its fuel from the main fuel tank on the vehicle, or, alternatively from the fuel tank included in the configuration. For main tank supply, the fuel intake circuit should be independent from the fuel pipes for other equipments on the vehicle. The fuel pipes should be φ6×1 copper pipes or CHINAUST pipes equipped with standard M12×1.25 taper joints. The joints should be securely fixed with air tightness. The fuel surface in the tank should be no lower than the heater center by 400mm or more. The oil-intake joint of the heater oil filter solenoid should be within 8m away from the tank (i.e., the fuel pipe length). Due to the long oil circuit, it may take a long time for the heater to start for the first time. You should wait 3 or 4 minutes. If the heater is not started after that, please shut down the heater and restart it. 如果您有机械翻译方面的需求，可以随时与我们的在线客服人员联系，也可以拨打我们的咨询热线：010-64809262. |
1611T5043E0-3EK border=0>
